Service Navigation

Order to Trade Ratio

Order to Trade Ratio

Eurex Exchanges will redesign the Order to Trade Ratio (OTR) with effect from 3 January 2018. Main changes compared to the current OTR regime are the switch from monthly to daily observation period and the introduction of a transaction based OTR.

The limits for the volume based OTR are set on the ratio between volume of all order-entries (ordered volume) and the trading volume per product and per day generated by orders and quotes sent by the Participants to T7. The limits for the Transaction based OTR are set on the ratio between number of all order-entries (number of orders) and the number of trades per product and per day generated by orders and quotes sent by the Participants to T7. For calculation of the ordered volume (respectively the number of orders), all types of orders and/or quotes are considered. This includes all of the following: add, modify and delete. For calculation of the traded volume (number of trades) all executions are taken into account. Please note, aggregation of volume and numbers is done on a daily basis.?

The limits are defined based on the product type. For some products with a different behaviour, the limits are increased by a product specific factor. In case a participant fulfilled the minimum quotation requirements the limits will be increased considering the quotation performance.

If the value of an OTR for a particular product for a particular Participant is greater than a pre-defined limit, such instance is considered a violation. Such a violation may trigger sanctions against the Participant.

Participants can calculate a preliminary value of the OTR as well as the respective limit by themselves with the supplied intraday reports. However, the conclusion on whether the OTR is violated can be drawn only at the end of a day.

?

Calculation Volume based OTR

The volume based OTR is calculated using the following equation:

OTR vol = [ ordered volume ]? /? [ traded volume ] - 1

The ordered volume is the sum of:

  • the number of contracts generated by orders and quotes that are accepted by the matching engine and entered in the order book and?
  • the number of contracts that the Participant deletes from the matching engine and thus have not been executed.

A modify of an order or quote is treated as a "delete" followed by an "add". Thus, the original order and the new order will both be counted towards the ordered volume. This process applies regardless of which attribute of the order and/or quote is changed. An IOC order is treated like an order submission, while the unexecuted portion will be treated like an order deletion.

If an order or a quote is fully or partially deleted by the Self-Match Prevention (SMP) functionality then the ordered volume is increased both on the buy- and the sell-side only by the number of the deleted contracts.

The traded volume is the executed volume in the order book. If the traded volume is smaller than the volume based minimum value, it is replaced with the volume based minimum value.

The limit of the volume based OTR considers the product type, the product. For participants fulfilling the minimum quotation requirements we apply higher and dynamic limits. The dynamic limits are depending on the quote performance (i.e. number of instruments and time with quotes in relation to the minimum requirements), the spread quality, the average quote size, as well as quotation during stressed market conditions.

Calculation Transaction based OTR

The transaction based OTR is calculated using the following equation:

? ? ? ? ? ? ? ? ? ? ? ? ? ? ? OTR count = [ number of orders ]? /? [ number of trades ] - 1


The number of orders is the sum of:?

  • the number orders and quotes that are accepted by the matching engine and entered in the order book and?
  • the number of orders the Participant deletes from the matching engine and thus have not been executed.

A modify of an order or quote is treated as a "delete" followed by an "add". Thus, the original order and the new order will both be counted towards the number of orders. This process applies regardless of which attribute of the order and/or quote is changed. An IOC order is treated like an order submission, while the unexecuted portion will be treated like an order deletion.

If an order or a quote is fully or partially deleted by the Self-Match Prevention (SMP) functionality then the number of orders is increased both on the buy- and the sell-side only by the number of involved orders.

The number of trades is the number of executions in the order book. If the number of trades is smaller than the transaction based minimum value, it is replaced with the transaction based minimum value.

The limit of the transaction based OTR considers the product type, and the product. For participants fulfilling the minimum quotation requirements we apply higher and dynamic limits. The dynamic limits are depending on the quote performance (i.e. number of instruments and time with quotes in relation to the minimum requirements), the spread quality as well as quotation during stressed market conditions.

Limit parameter

The following tables shows the parameters used to calculate the volume based OTR (Please note: The limit is based on the product type of the product):



If a product is not included in the table, i.e. has no product factor assigned, the default value of 1.00 is applied.

The following tables shows the parameters used to calculate the transaction based OTR (Please note: The limit is based on the product type of the product):

?


If a product is not included in the table, i.e. has no product factor assigned, the default value of 1.00 is applied.


Reports

The following reports will be available for the Participants on the Common Report Engine:

  • CB069 (Transaction Report): Enhanced report, which will be generated on a daily basis. Additionally, intra-day versions of the report are available three times a day.
  • TR100 (Order To Trade Ratio Report): New report which, will be generated on a daily basis. This report will be distributed starting 4 December 2017. After 3 January 2018, this report will replace the current TD981 report.

Under further information you can find a concept paper describing the calculation (including an example) in detail.

?
?

Please find below a concept paper describing the calculation (including an example) in detail.

?

Market Status

XEUR

-

-

Parts of the trading system are currently experiencing technical issues

The trading system is currently experiencing technical issues

Production newsboard

The market status window is an indication regarding the current technical availability of the trading system. It indicates whether news board messages regarding current technical issues of the trading system have been published or will be published shortly.

We strongly recommend not to take any decisions based on the indications in the market status window but to always check the production news board for comprehensive information on an incident.

An instant update of the Market Status requires an enabled up-to date Java? version within the browser.

  • 赵继:高校对社会最大的贡献就是提供人才 2019-02-11
  • 这里是乌鲁木齐市交警指挥中心,欢迎参与交通管理问题! 2018-12-12
  • 市场经济就是一种唯利是图的经济,是一种波动、走极端的经济,新时期的发展方式与结果就是如 此。那么指望市场经济来解决需要与不平衡的矛盾,对症下药了吗? 2018-09-16
  • 伦敦金融城是推进“一带一路”建设的忠实伙伴 2018-08-15
  • 一次金特会能让朝鲜半岛休兵? 2018-08-15
  • 天津滨海新区将建校外培训机构“黑白名单” 2018-08-13
  • 科技赋能助力医保革新,平安开启商保服务新模式 2018-08-13
  • 脆皮-热门标签-华商生活 2018-08-11
  • 上海国际电影节公布金爵奖片单 姚晨马伊琍新片入围 2018-08-09
  • 一语惊坛(6月5日):担当新使命,展现新作为。 2018-08-09
  • 金正恩对中国进行访问 2018-08-07
  • 两岸学者探讨中华文化未来使命 2018-08-02
  • 中日韩重拾合作势头,外界期待多 2018-08-01
  • 人民日报评论员:共同描绘历史新阶段的发展蓝图 2018-07-28
  • 池州扶贫干部借“朋友圈”帮贫困户卖竹篮 2018-07-27
  • 501| 133| 178| 329| 450| 994| 105| 540| 487| 783|